Please start the engine of your motorhome; the SAT system should retract automatically a few seconds later due to a safety cut-out.
If this was not successful, reset the SAT system by de-energising the vehicle. To do this, please switch off the control panel above the entrance door, disconnect the 230 V plug (if plugged in) from the power supply and then set the battery isolator switch on the electrical block (EBL) to OFF. After approx. 15 minutes, undo the whole procedure and try to retract the SAT system via the control unit.
If the SAT system still does not retract, you must manually remove the articulated arm including the parabolic reflector using the two screws on the joint and stow it safely in the rear garage of the vehicle before visiting the nearest Carado dealer, who can analyse and rectify the fault on site.